A hot air generator is a widely used hot air source configuration in industrial production, with a high heat conversion rate, easy to use, safe, and reliable. This equipment is applied to drying furnaces, capable of heating, drying, and sintering. It is used for drying and hardening of electronic components after installation, preheating and drying of spraying equipment components, etc. What are the causes of occasional malfunctions in the generator during the use of hot air? How to solve it? Fault - Unable to heat up
If the hot air causes the generator to fail to heat, it is highly likely that the internal heating device has malfunctioned. It may be due to a burnt electric heating wire or a broken junction box, causing a circuit connection failure.
To solve this problem, if the electric heating wire can be repaired, it should be repaired. If it cannot be directly replaced with a new one. If the connecting wire is broken or loose, simply reconnect the connecting circuit to ensure that the circuit is open and the circuit is unobstructed.
Fault 2: Electric heating tube rupture
If the electric heating tube of the hot air or generator ruptures, which means corrosion cracking or cracking, these will cause unclear heating effect, obvious heat leakage and other problems, not only wasting energy, but also potentially causing dangerous accidents and serious consequences.
So when such a problem occurs, it is necessary to first stop the operation of the equipment, wait for all the heat of the equipment to dissipate, cool to room temperature, and then carefully inspect the electric heating tube. Generally speaking, replacing the electric heating tube directly with a new one is safer.
Fault 3: If there is leakage in the hot air generator, which means that the automatic circuit breaker or leakage protection switch trips, it will cause the equipment to be unable to heat up and operate normally. To solve this problem, the first thing to do is to confirm the leakage location of the hot air generator and solve it according to various situations. If it is a problem with the electric heating tube and the insulation resistance cannot meet the standard during operation, then a new electric heating tube needs to be replaced. If the junction box is flooded, you need to use a hot air gun to blow dry the water inside. If the insulation layer of the equipment's wire is broken, it needs to be wrapped with insulating tape. For safety reasons, it is best to directly replace the cable with a new one.
The above is an introduction to the causes of faults caused by hot air and generators, as well as relevant solutions. We hope to help every user solve the problem as soon as possible. Of course, if there is a problem with the equipment, it is better to contact the manufacturer directly to avoid unnecessary trouble after self inspection.